Before Test Script is called once at the beginning of each test in a simulation.

 

It can be used to initialize variables used during the simulation.  For example, when there is a need access additional IPV properties and update them with specific information that will be the same throughout a test, this script is a good place to perform that task.

 

This script has access to the current parameter settings for the test.  It is also the script section where all the symbols in the portfolio are loaded into Trading Blox Builder memory.

 

Note:

Before Test, Set Parameters, and After Test to be thread locked so the script for each thread will complete without overlap from another thread.

 

GetSteppedParameter

---